A One Stop Solution
for your Engineering needs.
Fire and Smoke Dampers
ETD Series Dampers
Fire and smoke control panels and systems
Duct regulating dampers
Slim fit dampers
Slim seal dampers
Heavy duty regulating dampers
Single blade dampers
Over pressure dampers
Mechanical flow rate controllers
Pressure Independent VAV
By Pass VAV
Fire Dampers for Explosive atmosphers
Fire Protection Valves
Circular single blade Fire and smoke dampers
Circular single blade fire and Volume control dampers
Fire dampers are passive fire protection products used in heating, ventilation, and air conditioning (HVAC) ducts to prevent the spread of fire inside the ductwork through fire-resistance rated walls and floors. Fire/smoke dampers are similar to fire dampers in fire resistance rating, and also prevent the spread of smoke inside the ducts. When a rise in temperature occurs, the fire damper closes, usually activated by a thermal element which melts at temperatures higher than ambient but low enough to indicate the presence of a fire, allowing springs to close the damper blades. Fire dampers can also close following receipt of an electrical signal from a fire alarm system utilising detectors remote from the damper, indicating the sensing of heat or smoke in the building occupied spaces or in the HVAC duct system.
Also known as a Volume Balancing Damper, air control dampers are used in situations to control airflow and are considered medium to heavy duty. Available in parallel blade when greater control is required near the top end of the damper or for systems requiring position operation (fully opened or fully closed), as well as opposed blade in applications where it is necessary to maintain even distribution of air downstream from the damper. We can install motors on to an extended shaft, as well as a manual hand quadrant. Jamb and blade seals are an option to assist in the decrease of airflow on these dampers that can be made as galvanized, stainless or aluminum.
A damper is a valve or plate that stops or regulates the flow of air inside a duct, chimney, VAV box, air handler, or other air handling equipment. A damper may be used to cut off central air conditioning (heating or cooling) to an unused room, or to regulate it for
room-by-room temperature and climate control. Its operation can be manual or automatic. Manual dampers are turned by a handle on the outside of a duct. Automatic dampers are used to regulate airflow constantly and are operated by electric or pneumatic motors, in turn
controlled by a thermostat or building automation system. Automatic or motorized dampers may also be controlled by a solenoid, and the degree of air-flow calibrated, perhaps according to signals from the thermostat going to the actuator of the damper in order to modulate the
flow of air-conditioned air in order to effect climate control.
In a chimney flue, a damper closes off the flue to keep the weather (and birds and other animals) out and warm or cool air in. This is usually done in the summer, but also sometimes in the winter between uses. In some cases, the damper may also be partly closed to help control the rate of combustion. The damper may be accessible only by reaching up into the fireplace by hand or with a woodpoker, or sometimes by a lever or knob that sticks down or out. On a wood-burning stove or similar device, it is usually a handle on the vent duct as in an air conditioning system. Forgetting to open a damper before beginning a fire can cause serious smoke damage to the interior of a home, if not a house fire.